Updating firmware thomson speedtouch 530 www dating4 com
Hi, I'd like to use the Be-supplied Speedtouch TG585 v7 with my new C&W service but it's requesting a static IP, etc and my new service is dynamic but requires a login.Is there a way to install a new firmware (it's currently using the Be Software Release 220.127.116.11)?I have downloaded the correct dynamic IP template from the Be site (Dyn.tpl), but how on earth do I actually install it on the bebox? The profile settings are stored in an .ini, but the Be templates are in a different format and apparently need to be uploaded to the router via FTP. So I have my fast new internet connection, but the wrong router!Can any of you wise folks recommend a good router which would be suitable for the C&W LLU network? The firmware installs fine (18.104.22.168) and recognises the Speedtouch 585 v7 as an O2 box. Type: ETHo A C&W has supplied static IP, login and password. The Be / O2 box insists on the following: Static IP address, Subnet Mask and Default Gateway.I know these have been answered before but I'm hoping you won't mind me asking again, for 2009: What is the latest firmware for the Thomson Speedtouch 516v6 that works with Teksavvy? » ··· 4421What is the last firmware that works with DMT? Are there other programs that work with the latest firmware for looking at line stats? *******************My modem is resetting every few minutes at the worst of times and twice a day at the best. tried all the usual like admin, Administrator / Serial Number, etc. So, can't setup it up as dynamic and can't connect to upload any new templates!! but paradoxically you may need an additional unlocked TG585v7 router to do it... may be you best bet rather than mess with the Be Box. Re "the eprom chip needs to be reset by a soldering iron ...".
Or do I misread your post, as it could mean the wall has a Be EPROM in it? The Administrator / Serial # doesn't work, nor do all the other combinations tried on various forums.
IIRC the login name for generic fw on the 585 is the admin or administrator, maybe with the initial "a" capitalised. My bog standard 585 is somewhere half way across the loft sorry. It contains all the generic options for Administrator that have been removed in those firmwares.
IIRC the login name for generic fw on the 585 is the admin or administrator, maybe with the initial "a" capitalised. My bog standard 585 is somewhere half way across the loft sorry.
Problem is, it's asking for the same Static IP, Default Gateway and when you select 'setup', so I can see no option to set it up with the details provided for C&W LLU service. Other crazy thing is this: If I try and connect by FTP to upload a template and/or use the restore/backup utility at
be=0&l0=0&l1=1&tid=BACKUP_RESTORE, it requests a user/pass NOTHING works ..